Product ID:WALLHIDE LINE SEMI GLOSS, 27-A (041390M)
MSDS Date:06/01/1990
FSC:8010
NIIN:00N062923
MSDS Number: BYSXX

PPG INDUSTRIES INC

260 KAPPA DR
PITTSBURGH, PA 15272
US

Emergency Phone: 304-843-1300

Info Phone: 412-492-5555

Cage: DO542

PPG INDUSTRIES INC. COATINGS & RESINS GP

9 ALLISON PARK, PA 15101

Telephone: 412-492-5555

Cage: DO542

ALUMINUM SILICATE

CAS: 1335-30-4

Fraction By Weight: 2-5%

OSHA PEL N/K

ACGIH TLV: N/K

1); (CALCIUM CARBONATE)

CAS: 471-34-1

RTECS: FF9335000

Fraction By Weight: 20-25%

OSHA PEL N/K

ACGIH TLV: N/K

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 25-30%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

NAPHTHOL SPIRITS; (HYDROTREATED HEAVY NAPHTHA)

CAS: 64742-48-9

Fraction By Weight: 35-40%

OSHA PEL N/K

ACGIH TLV: N/K

FILM FORMERS, RESINS, & ADDITIVES

Fraction By Weight: 30-35%

OSHA PEL N/K

ACGIH TLV: N/K

DUSTS FROM COATINGS IS VERY LIMITED. SINCE

RTECS: 9999999ZZ

HAZARD FOR MAN.

RTECS: 9999999ZZ

INGESTION, EXCESSIVE EXPOSURE TO CORROSIVE

RTECS: 9999999ZZ

EXPOS LIMS, LEL BELOW STATED LIM & TO REMOVE DECOMP

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INGEST: HARMFUL/FATAL IF SWALLOWED.
EYES: CAUSES IRRITATION. REDNESS, ITCH, BURNING SENSATION & VISUAL
DISTURBS MAY INDICATE EXCESS EYE CNTCT. SKIN: MAY CAUSE MOD IRRIT.
DRYNESS, ITCH, CRACKING, BURNI NG, REDNESS & SWELL ARE CNDTNS ASSOC
W/EXCESS SKIN CNTCT. INHAL: VAP & SPRAY MIST MAY BE HARMFUL IF
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: INHALED. CHRONIC: AVOID LONG TERM &
RPTD CNTCT. PROD CNTNS TITANIUM DIOXIDE. ANIMALS INHAL MASSIVE QTYS
OF TITANIUM DIOXIDE DUST IN LONG-TERM STUDY DEVELOPED TUMORS.
STUDIES W/HUMANS INVOLVE D IN MFR OF THIS PIGMENT INDICATE NO
INCREASED RISK OF CANCER FROM EXPOS. POTNTL FOR INHAL OF TITANIUM
DIOXIDE (ING 6)
Medical Cond Aggravated by Exposure:NOT APPLICABLE.

First Aid:INGEST: DO NOT INDUCE VOMIT. EYES: FLUSH EYES IMMED W/PLENTY
OF WATER FOR AT LEAST 15 MIN. SKIN: REMOVE PROMPTLY BY WIPING
FOLLOWED BY WATERLESS HAND CLEANER & SOAP & WATER. INHAL: REMOVE TO
FRESH AIR . APPLY ARTF RESP & OTHER SUPPORTIVE MEASURES AS REQD.
OTHER: IF ANY OF FOLLOWING OCCUR DURING/FOLLOWING USE OF THIS PROD,
CNTCT POIS CTL CTR, EMER ROOM OR MD IMMED; HAVE MSDS INFO AVAIL:
(ING 8)

Flash Point Method:PMCC
Flash Point:120F,49C
Lower Limits:0.7%
Extinguishing Media:USE NFPA CLASS B EXTINGS (CARBON DIOXIDE, DRY CHEM
OR UNIVERSAL AW FILM FORMING FOAM) DESIGNED TO EXTING NFPA (SUPDAT)
Fire Fighting Procedures:USE NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP.
WATER SPRAY MAY BE INEFTIVE. WATER SPRAY MAY BE USED TO COOL CLSD
CNTNRS TO PVNT PRESS BUILDUP & (SUPDAT)
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD. ISOLATE FROM
HEAT, ELEC EQUIP, SPKS & OPEN FLAMES. CLSD CNTNRS MAY EXPLODE WHEN
EXPOS TO EXTREME HEAT. DO NOT APPLY ON HOT (SUPDAT)

Spill Release Procedures:PROVIDE MAX VENT. ONLY PERS EQUIPPED W/PROPER
RESP & SKIN & EYE PROT SHOULD BE PERMITTED IN AREA. REMOVE ALL
SOURCES OF IGNITION. TAKE UP SPILLED MATERIAL W/SAWDUST,
VERMICULITE OR OTHER ABSORBENT MAT ERIAL & PLACE INTO CONTAINERS
FOR DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE ABOVE 120F. STORE LARGE
QUANTITIES IN BUILDINGS DESIGNED AND PROTECTED FOR STORAGE OF NFPA
CLASS II COMBUSTIBLE LIQUIDS.
Other Precautions:IF MATL IS PART OF MULTIPLE COMPONENT COATING SYS,
READ MSDS FOR THE OTHER COMPONENT(S) BEFORE BLENDING AS RSLTG MIX
MAY HAVE HAZS OF ALL ITS PARTS. CNTNRS SHOULD BE GROUNDED WHEN
POURING. AVOID FREE FALL OF LIQS IN EXCESS OF FEW INCHES.

Respiratory Protection:WHERE VENTILATION IS INADEQUATE, USE A SUITABLE,
NIOSH/MSHA APPROVED RESPIRATOR.
Ventilation:PROVIDE GEN DILUTION OR LOC EXHST VENT IN VOL & PATTERN TO
KEEP CONC OF LISTED INGREDS BELOW LOWEST SUGGESTED (ING 9)
Protective Gloves:NITRILE RUB OR NEOPRENE RUB OR PVA
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:WEAR PROTECTIVE CLOTHING INCLUDING
IMPERMEABLE APRON.
Work Hygienic Practices:CLEAN OR DISCARD CONTAMINATED CLOTHING AND
SHOES.
Supplemental Safety and Health
EXTING MEDIA: CLASS II COMBUST LIQ FIRES. FIRE FIGHT PROC: POSS
AUTOIGNIT/EXPLOS WHEN EXPOS TO EXTREME HEAT. IF WATER IS USED, FOG
NOZZS ARE PREF. EXPLO HAZ: SURFS. TOXIC GASES MAY FORM WHEN PROD IS
C ONTACTED BY FLAME/HOT SURFACES. HAZ DECOMP PRODS: INCLUDING
CARBON MONOXIDE, ZINC OXIDE.

Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:<1
Vapor Density:HVR/AIR
Spec Gravity:1.1-1.3
Evaporation Rate & Reference:12 (BUOAC=100)
Solubility in Water:0.0%
Appearance and Odor:VISCOUS LIQUID WITH AN ODOR CHARACTERISTIC OF THE
LISTED SOLVENTS.
Percent Volatiles by Volume:<55

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG ALKALIES, STRONG MINERAL ACIDS OR STRONG
OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE HAZ DECOMP PRODS WHEN
HEATED. WELDING/BRAZING/FLAME CUTTING ON SURFS COATED W/PROD MAY
PRDCE FUMES (SUPDAT)

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, PROVINCIAL AND LOCAL ENVIRONMENTAL CONTROL
REGULATIONS. EMPTY CONTAINERS SHOULD BE RECYCLED OR DISPOSED OF
THROUGH AN APPROVED MAN AGEMENT FACILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.